Full Band Wireless High Power Signal Jammer DDS Stationary RCIED Bomb Jammer

Product Specification

High Power Stationary RCIED Bomb Jammer, High Power DDS Jammer, Full Band Wireless Signal Jammer

User Manual - > Remote Controlled Improvised Explosive Device Jamm...

Product Instruchtion

Now let us introduce this mobile signal jammer to you and give you better understanding of the positions of all the buttons, functions of accessories and other hardware.

Control Panel

Tag:Front Panel View

Tag: Back Panel View

Tag: RF POWER SWITCH

Press the green light button to activate corresponding power amplifier

Tag: Warning LED

Red Light With VSWR Warning

Tag: Each is 31dB adjustable output power adjustable step is 1dB

Product Technique characteristics

• Taking use of super-high frequency with high effective power.
• Effective output power (channel power) and bigger interfere radius.
• Only interfere downlink frequency of mobile system,without disturb normally working of Base Stations.
• Imported elements: Slow start up design of circuit. These elements can maintain the stable operation condition with high integration. A combination of the Israeli and United states of American Technology. Most sensitive Components imported from Germany, Hungary and Japan.

Product Parameter specifications

System fittings

     System fittings consist of block package, panel antenna, antenna connecter lines (cable and N connecters) etc. 10 modules are responsible respectively for CDMA, GSM, DCS,WiFi,WLAN, which controls adjustment of output power, power switcher, as well as kinds of alarms( over heating and VSWR) . The next step will provide the function of each fitting in brief.

Anntenna

The jammer you bought is made up of jammer and antennas. It contains 10 modules(CH1~CH10).Each module can adjust power, warning standing wave indicator and warning temperature indicator separately.

• Omni antenna

Frequency: 20~88MHz,88~155MHz,300~450MHz ( total 3pcs ).

Gain : 3dbi.

Connector type : N type

Photo:

Vertical Ichnography:

• Directional Board antenna

Frequency:925~960MHz/1805~1880MHz,851~894/2110-2170MHz,1570.42~1580.42/2400~2483.5MHz,1930~1990MHz ( total 7pcs )

Gain:12-15dbi

Interface: N type

Photo:

Vertical Ichnography:

Using Guide

Step 1: opens the box

• Open the box. Keep unpacked boxes ready for future removal or shipment.
• Check that the open equipment and accessories are in good condition. If you find any existing defects or damage, please contact your supplier as soon as possible.

Step 2: connecting cables and antennas

• Coaxial cables are mainly used for the connection of antennas and shields.    
• (Note: do not activate the shield until the antenna and shield are not well connected, otherwise, the shield will be severely damaged. All costs and consequences arising therefrom will be borne by the user himself)
• Cable the antenna to the mainframe port one-to-one.
• Insert the cylindrical end of the 3 pin AC input power cord into the "AC220V" AC power outlet of the host, and insert the 3 pin head end into the power supply socket.

Step 3: Start shield

• Press the RF switch and the amplifier starts working while the orange light in the RF switch is lit.
• The minimum output power of the shield can be adjusted by the dial disk of the front panel (control panel) of the host machine according to the actual situation in the field.

Step4: Turn off the shield

• Press the RF switch that has already lit the orange lamp, the orange light goes out, the power amplifier stops working.
• Disconnect "AC 220V" AC Power Line from Power supply.
• Remove antenna connection cable.