PHiliph Goldway G30 Patient Monitor Display G104SN03 E204356 Hospital Medical

Product Specification

Hospital Medical Parts PHiliphh Goldway G30 patient monitor display G104SN03 E204356

PHiliphh Goldway G30 patient monitor display G104SN03 E204356

► Brief Introduction

This specification applies to the Color Active Matrix Liquid Crystal Display G104SN03 V5 composed of a TFT-LCD display, a driver and power supply circuit, and a LED backlight system. The screen format is intended to support SVGA (800(H) x 600(V)) screen and 16.2M (RGB 8-bits) or 262k colors (RGB 6-bits). LED driving board for backlight unit is included in G104SN03 V5 and the LED unit is replaceable. All input signals are LVDS interface and compatible with G104SN03 V1. G104SN03 V5 designed with wide viewing angle; wide temperature and long life LED backlight (30k hrs) is well suited for industial applications.

G104SN03 V5 is a RoHS product.

► Operating Precautions

1. Since front polarizer is easily damaged, please be cautious and not to scratch it.
2. Be sure to turn off power supply when inserting or disconnecting from input connector.
3. Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4. When the panel surface is soiled, wipe it with absorbent cotton or soft cloth.
5. Since the panel is made of glass, it may be broken or cracked if dropped or bumped on hard surface.
6. To avoid ESD (Electro Static Discharde) damage, be sure to ground yourself before handling TFT-LCD Module.
7. Do not open nor modify the module assembly.
8. Do not press the reflector sheet at the back of the module to any direction.
9. In case if a module has to be put back into the packing container slot after it was taken out from the container, do not press the center of the LED light bar edge. Instead, press at the far ends of the LED light bar edge softly. Otherwise the TFT Module may be damaged.
10. At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface Connector of the TFT Module.
11. TFT-LCD Module is not allowed to be twisted & bent even force is added on module in a very short time. Please design your display product well to avoid external force applying to module by end-user directly.
12. Small amount of materials having no flammability grade is used in the LCD module. The LCD module should be supplied by power complied with requirements of Limited Power Source (IEC60950 or UL1950), or be applied exemption.
13. Severe temperature condition may result in different luminance, response time and lamp ignition voltage.
14. Continuous operating TFT-LCD display under low temperature environment may accelerate lamp exhaustion and reduce luminance dramatically.
15. The data on this specification sheet is applicable when LCD module is placed in landscape position.
16. Continuous displaying fixed pattern may induce image sticking. It’s recommended to use screen saver or shuffle content periodically if fixed pattern is displayed on the screen.

► Specification

► More Services

In addition to the sales of medical equipment, accessories and maintenance accessories, we also specialize in the maintenance of such machines and modules. As we are proficient in the maintenance of hospital equipment, we are good at renovating damaged machines and accessories. Therefore, if you have such machines or modules for maintenance, you can contact us and send them to us, and we will repair them at the fastest speed. But it is important to note that you must make sure that the items to be serviced are not opened and never serviced. Otherwise, it is unacceptable to us. Finally, please check your items carefully before sending them out.

Looking forward to receiving your early inquiry. Thank you for your time!