Kjellberg Hifocus Accessories .11.848.201.1522 G4022 Swril Gas Cap For Plasma

Product Specification

Kjellberg Hifocus Accessories .11.848.201.1522 G4022 Swril Gas Cap For Plasma Cutter Machine
 
In recent years, we have been sold in lots of countries and regions in Europe and Asia and gained good reputation widely with excellent quality . In order to meet customers’ requirements and improve product quality, our company has already realized mechanical processing numerical control automatization production, and been committed to manufacturing products with best quality.
Our company adopts modern management mode and devotes itself to new high performance design and production of welding & cutting equipments, with continuous technique advantages innovation .All our staff are striving to realize the aim of "Create Chinese Brand ,Build First-Class Enterprise ",with the spirit of "Being honest and pragmatic ,making pioneering efforts and seeking perfection with persistency."
Company commitment: thinking what customers think, worrying what customers worry, in time delivery and high tracking service.
 

 
Technical Support:
plasma cutting arc fault analysis
 
1. cutting torch nozzle and electrode
 
Since the nozzle installation is improper, such as threads are not tightened, equipment of each block bit improper adjustment, need water cooling of the torch at work, not in accordance with the requirements of pass into the flow of cooling water and frequent arcs, will cause premature failure of the nozzle. Solution is, in accordance with the requirement of technology of the workpiece cutting and the correct adjustment of equipment gear, check the torch nozzle is installed firmly is, through the cooling water nozzle should be made in advance in cooling water circulation up. When cutting, cutting torch and workpiece thickness adjustment according to workpiece distance.
 
2. input AC voltage is too low
 
Plasma cutting machine using the site has a large power use facilities, cutting machine internal main circuit components, etc., will make the input AC voltage is too low. The solution is to check whether there is enough capacity of the power supply line to meet the requirements of the power line of the power supply line in the plasma cutting machine. Plasma cutting machine installation location, should be far away from large electrical equipment and often have electrical interference place. In the use of the process, to regularly clean up the dust and dirt on the components in the cutting machine, check whether the wire aging phenomenon, etc..
 
3. earth wire and workpiece contact
 
Grounding is an essential preparation before cutting. Without special grounding tool, the workpiece surface with insulation and long-term use of aging serious ground wire, etc., will make the earth and the workpiece contact. Solution: use a special grounding tool, and check whether the insulation effects of the ground and the workpiece surface contact, avoid the use of aging grounding wire.
 
4. spark generator can not automatically cut off
 
Plasma cutting machine work, first of all to ignite the plasma arc, by the high frequency oscillator excited gas between the electrode and the inner wall of the nozzle, resulting in high-frequency discharge, the gas ionization and the formation of local small arc, the small arc by compressed air, ejected from the nozzle to ignite plasma arc. This is main task spark generator. Under normal circumstances, the working time of the spark generator is only 0. 5 ~ 1s, can not be automatically cut off the reasons for the general control circuit board components, the discharge electrode gap between the spark generator is not suitable. Solution: should always check the spark generator discharge electrode, so that the surface is smooth, timely adjustment of the discharge electrode gap of the spark generator (0. 8 ~ 1. 2mm), if necessary, replace the control panel.